User's Manual 2. Software Package
Version 6.6 13 MediaPack Series
2 Software Package
After installing and powering up the device, you are ready to install the utilities that are
included in the software package. This software package must be installed on the host
PC/machine to be used to manage the device. The software package can be downloaded
by registered users from the AudioCodes Web site at www.audiocodes.com/support.
To become a registered user, follow the instructions on the Web site.
To get started:
1. To install the software package refer to Installing the Software Package on page 13.
2. Check the software package contents (refer to 'Software Directory Contents &
Structure' on page 14.)
3. Perform 'Getting Started' on page 15.
2.1 Installing the Software Package
The software package is available on the AudioCodes' FTP Web site.
Customers using a Windows™ operating system may choose to install the package
via the installation wizard, or choose to unzip the software package from the supplied
zip file (refer to "Installing/Unzipping When Using a Windows™ Operating System"
below).
2.1.1 Installing/Unzipping When Using a Windows™ Operating System
To install the package:
1. Double-click on the setup.exe executable file.
2. Follow on-page instructions.
To unzip when using a Windows™ Operating System:
1. Using a tool like WinZip™, open the zip file.
2. Click the ‘Extract’ button; the ‘Extract’ page opens.
3. Navigate to the directory that you require to be the root directory for the installation
and click the ‘Extract’ button; the files are extracted to the location you specified.
2.1.2 Unzipping When Using a Linux™/Solaris™ Operating System
To unzip when using a Linux™/Solaris™ Operating System:
1. To open the tar.Z archive, un-compress the tar.Z file.
2. Enter the command: tar -xvf xxxxxx.tar.
To Next Page
Loading...
