EasyManuals Logo

AudioCodes MSBG Series User Manual

AudioCodes MSBG Series
1195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1055 background imageLoading...
Page #1055 background image
Version 7.2 1055 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime, FwdInfo_Module, FwdInfo_Port;
[\FwdInfo]
Where,
ï‚§ Module = Module number, where 1 denotes the module in Slot 1.
ï‚§ Port = Port number, where 1 denotes Port 1 of a module.
For example:
ï‚§ Below configuration forwards calls originally destined to Port 1 of
Module 1 to "1001" upon On Busy:
FwdInfo 0 = 1,1001,30,1,1;
ï‚§ Below configuration forwards calls originally destined to Port 2 of
Module 1 to an IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30,1,2;
For a detailed description of the table, see Configuring Call Forward on
page 584.
Note: The parameter is applicable only to analog interfaces.
Call Forward Reminder Ring Parameters
Note:
ï‚§ These parameters are applicable only to FXS interfaces.
ï‚§ For a description of this feature, see Call Forward Reminder Ring on page 541.
Enable NRT Subscription
configure voip > gateway
dtmf-supp-service supp-
service-settings > nrt-
subscription
[EnableNRTSubscription]
Enables endpoint subscription for Ring reminder event notification
feature.
ï‚§ [0] Disable (default)
ï‚§ [1] Enable
AS Subscribe IPGroupID
configure voip > gateway
dtmf-supp-service supp-
service-settings > as-
subs-ipgroupid
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).
NRT Subscribe Retry
Time
configure voip > gateway
dtmf-supp-service supp-
service-settings > nrt-sub-
retry-time
[NRTSubscribeRetryTime]
Defines the Retry period (in seconds) for Dialog subscription if a previous
request failed.
The valid value range is 10 to 7200. The default is 120.
Call Forward Ring Tone
ID
configure voip > gateway
dtmf-supp-service supp-
service-settings > cfe-
ring-tone-id
[CallForwardRingToneID]
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.

Table of Contents

Other manuals for AudioCodes MSBG Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MSBG Series and is the answer not in the manual?

AudioCodes MSBG Series Specifications

General IconGeneral
BrandAudioCodes
ModelMSBG Series
CategoryGateway
LanguageEnglish

Related product manuals