EasyManuals Logo

AudioCodes MSBG Series User Manual

AudioCodes MSBG Series
1195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1132 background imageLoading...
Page #1132 background image
User's Manual 1132 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
Note: The parameter can be configured for a Tel Profile.
[EnablePulseDialDetection] Enables the device to detect pulse (rotary) dialing from analog
equipment (e.g., telephones) connected to the device's FXS
port interfaces.
ï‚§ [0] Disable (default)
ï‚§ [1] Enable
Note: For the parameter to take effect, a device reset is
required.
[EnablePulseDialGeneration] Enables pulse dialing generation to the analog side (FXO)
when dialing is received from the IP side.
ï‚§ [0] Disable = (Default) Device generates DTMF signals to
the FXO side.
ï‚§ [1] Enable = Device generates pulse dialing to the FXO
side.
Note: For the parameter to take effect, a device reset is
required.
[PulseDialGenerationBreakTime] Defines the duration of the Break connection (off-hook) for
FXO pulse dial generation.
The valid value range is 20 to 120 (in msec). The default is 60.
Note: For the parameter to take effect, a device reset is
required.
[PulseDialGenerationMakeTime] Defines the duration of the Make connection (on-hook) for
FXO pulse dial generation.
The valid value range is 20 to 120 (in msec). The default is 40.
Note: For the parameter to take effect, a device reset is
required.
[PulseDialGenerationInterDigitTime] Defines the inter-digit duration (time between consecutively
dialed digits) for FXO pulse dial generation.
The valid value range is 300 to 1500 (in msec). The default is
700.
Note: For the parameter to take effect, a device reset is
required.
62.10.12 Trunk Groups and Routing Parameters
The routing parameters are described in the table below.
Table 62-67: Routing Parameters
Parameter Description
Trunk Group Table
Trunk Group Table
configure voip > gateway trunk-
group
[TrunkGroup]
Defines and activates Trunk Groups.
The format of the ini file table parameter is as follows:
[TrunkGroup]
FORMAT TrunkGroup_Index = TrunkGroup_TrunkGroupNum,
TrunkGroup_FirstTrunkId, TrunkGroup_FirstBChannel,
TrunkGroup_LastBChannel, TrunkGroup_FirstPhoneNumber,

Table of Contents

Other manuals for AudioCodes MSBG Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MSBG Series and is the answer not in the manual?

AudioCodes MSBG Series Specifications

General IconGeneral
BrandAudioCodes
ModelMSBG Series
CategoryGateway
LanguageEnglish

Related product manuals