Version 7.2 835 Mediant 1000B Gateway & E-SBC
User's Manual 53. Viewing Network Status
53 Viewing Network Status
This section describes how to view network-related status.
53.1 Viewing Active IP Interfaces
You can view the device's active IP interfaces that are configured in the IP Interfaces table
(see ''Configuring IP Network Interfaces'' on page 135).
To view active IP network interfaces:
Open the IP Interface Status page (Monitor menu > Monitor tab > Network Status
folder > IP Interface Status).
53.2 Viewing Ethernet Device Status
You can view the status of configured Ethernet Devices that have been successfully
applied. To configure Ethernet Devices, see ''Configuring Underlying Ethernet Devices'' on
page 132.
To view Ethernet Device status:
Open the Ethernet Device Status page (Monitor menu > Monitor tab > Network
Status folder > Ethernet Device Status).
53.3 Viewing Ethernet Port Information
You can view status information of the device's Ethernet ports. To configure Ethernet ports,
see ''Configuring Underlying Ethernet Devices'' on page 132
Note: If the device is operating in High-Availability mode, you can also view Ethernet
port information of the redundant device, by opening the Redundant Ethernet Port
Information page (Monitor menu > Monitor tab > Network Status folder > Redundant
Ethernet Port Information).
To view Ethernet port information:
Open the Ethernet Port Information table, by doing one of the following:
• Navigation tree: Monitor menu > Monitor tab > Network Status folder >
Ethernet Port Information.
• Monitor home page: Click an Ethernet port on the graphical display of the device
(see ''Viewing Device Status on Monitor Page'' on page 797).
To Next Page
Loading...
Need help?
General
