Version 7.2 75 Mediant 1000B Gateway & E-SBC
User's Manual 7. CLI-Based Management
7 CLI-Based Management
This chapter provides an overview of the CLI-based management and provides
configuration relating to CLI management.
Note:
• By default, CLI is disabled (for security purposes).
• The CLI can only be accessed by management users with the following user
levels:
√ Administrator
√ Security Administrator
√ Master
• For a description of the CLI commands, refer to the CLI Reference Guide.
7.1 Getting Familiar with CLI
This section describes the basic structure of the device's CLI, which you may need to know
before configuring the device through CLI.
7.1.1 Understanding Configuration Modes
Before you begin your CLI session, you should familiarize yourself with the CLI command
modes. Each command mode provides different levels of access to commands, as
described below:
Basic command mode: Initial mode that is accessed upon a successful CLI login
authentication. Any user level can access the mode and thus, the commands
supported by this command tier are limited, as is interaction with the device itself. The
mode allows you to view various information (using the show commands) and activate
various debugging capabilities.
Welcome to ...
Username: Admin
Password:
>
The Basic mode prompt is ">".
Enable command mode: The mode is the high-level tier in the command hierarchy,
one step up from the Basic mode. A password ("Admin", by default) is required to
access the mode after you have accessed the Basic mode. The mode allows you to
configure all the device's settings. The Enable mode is accessed by typing the
following commands:
> enable
Password: <Enable mode password>
#
The Enable mode prompt is "#".
Note: The default password for accessing the Enable mode is "Admin" (case-
sensitive). To change this password, use the CLIPrivPass ini file parameter.
To Next Page
Loading...
Need help?
General
