AudioCodes MSBG Series User Manual

User's Manual 1068 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
MlppServiceDomain:123abc, MlppPrecLevel:5
Fac(1c): 91 a1 15 02 01 05 02 01 19 30 0d 0a 01 05 0a 01 01
04 05 01 00 12 3a bc
 MLPPNetworkIdentifier set to 490:
PlaceCall- MLPPNetworkID:9004
MlppServiceDomain:123abc, MlppPrecLevel:5
Fac(1c): 91 a1 15 02 01 0a 02 01 19 30 0d 0a 01 05 0a 01 01
04 05 90 04 12 3a bc
Note: The parameter is applicable only to digital interfaces.
MLPP Default Service Domain
mlpp-dflt-srv-domain
[MLPPDefaultServiceDomain]
Defines the MLPP default service domain string. If the device
receives a non-
MLPP ISDN incoming call (without a Precedence
IE), it uses the parameter (if different than “FFFFFF”) as a
Service domain in the SIP Resource-Priority header in outgoing
(Tel-to-IP calls) INVITE messages. The parameter is used in
conjunction with the parameter SIPDefaultCallPriority.
If MLPPDefaultServiceDomain is set to 'FFFFFF', the device
interworks the non-MLPP ISDN call to non-MLPP SIP call, and
the outgoing INVITE does not contain the Resource-Priority
header.
The valid value is a 6 hexadecimal digits. The default is
"000000".
Note: The parameter is applicable only to the MLPP NI-2 ISDN
variant with CallPriorityMode set to 1.
Note: The parameter is applicable only to digital interfaces.
Precedence Ringing Type
precedence-ringing
[PrecedenceRingingType]
Defines the index of the Precedence Ringing tone in the Call
Progress Tones (CPT) file. This tone is used when the
parameter CallPriorityMode is set to 1 and a Precedence call is
received from the IP side.
The valid range is -1 to 16. The default is -1 (i.e., plays standard
ringing tone).
Note: The parameter is applicable only to analog interfaces.
e911-mlpp-bhvr
[E911MLPPBehavior]
Defines the E911 (or Emergency Telecommunication
Services/ETS) MLPP Preemption mode:
 [0] = (Default) Standard Mode - ETS calls have the highest
priority and preempt any MLPP call.
 [1] = Treat as routine mode - ETS calls are handled as
routine calls.
Note: The parameter is applicable only to analog interfaces.
resource-prio-req
[RPRequired]
Determines whether the SIP resource-priority tag is added in the
SIP Require header of the INVITE message for Tel-to-IP calls.
 [0] Disable = Excludes the SIP resource-priority tag from the
SIP Require header.
 [1] Enable = (Default) Adds the SIP resource-priority tag in
the SIP Require header.
Note: The parameter is applicable only to MLPP priority call
handling (i.e., only when the CallPriorityMode parameter is set
to 1).
Multiple Differentiated Services Code Points (DSCP) per MLPP Call Priority Level (Precedence)
Parameters

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English