AudioCodes MSBG Series User Manual

Version 7.2 1081 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
Note: The parameter is applicable only if the parameter
TDMBusClockSource is set to 4 and the parameter
TDMBusPSTNAutoClockEnable is set to 0.
TDM Bus Enable Fallback
[TDMBusEnableFallback]
Defines the automatic fallback of the clock.
 [0] Manual (default)
 [1] Auto Non-Revertive

[2]
Auto Revertive
TDM Bus Fallback Clock Source
[TDMBusFallbackClock]
Determines the fallback clock source on which the
device synchronizes in the event of a clock failure.
 [4] Network (default)
 [8] H.110_A
 [9] H.110_B
 [10] NetReference1
 [11] NetReference2
TDM Bus Net Reference Speed
[TDMBusNetrefSpeed]
Defines the NetRef frequency (for both generation and
synchronization).
 [0] 8 kHz (default)
 [1] 1.544 MHz
 [2] 2.048 MHz
TDM Bus PSTN Auto FallBack Clock
configure voip > media tdm > pstn-bus-
auto-clock
[TDMBusPSTNAutoClockEnable]
Enables the PSTN trunk Auto-Fallback Clock feature.
 [0] Disable = (Default) Recovers the clock from the
trunk line defined by the parameter
TDMBusLocalReference.
 [1] Enable = Recovers the clock from any connected
synchronized slave trunk line. If this trunk loses its
synchronization, the device attempts to recover the
clock from the next trunk. Note that initially, the
device attempts to recover the clock from the trunk
defined by the parameter TDMBusLocalReference.
Note:
 For the parameter to take effect, a device reset is
required.
 The parameter is applicable only if the
TDMBusClockSource parameter is set to 4.
TDM Bus PSTN Auto Clock Reverting
configure voip > media tdm > pstn-bus-
auto-clock-reverting
[TDMBusPSTNAutoClockRevertingEnable]
Enables the PSTN trunk Auto-Fallback Reverting
feature. If enabled and a trunk returning to service has
an AutoClockTrunkPriority parameter value that is
higher than the priority of the local reference trunk (set in
the TDMBusLocalReference parameter), the local
reference reverts to the trunk with the higher priority that
has returned to service for the device's clock source.
 [0] Disable (default)
 [1] Enable
Note:
 For the parameter to take effect, a device reset is
required.
 The parameter is applicable only when the
TDMBusPSTNAutoClockEnable parameter is set to

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English