User's Manual 1110 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
after it completes dialing (to the Tel side, for analog
interfaces).
Typically, this feature is used only when early media (enabled
using the EnableEarlyMedia parameter) is used to establish
the voice path before the call is answered.
Note:
 FXO interfaces: The feature is applicable only to one-stage
dialing (FXO).
 Digital interfaces: To activate the feature, set the
EnableDSPIPMDetectors parameter to 1.
 Digital interfaces: The parameter is applicable only when
the protocol type is CAS.
GW Max Call Duration
configure voip > sip-definition
settings > gw-mx-call-duration
[GWMaxCallDuration]
Defines the maximum duration (in minutes) per Gateway call.
If this duration is reached, the device terminates the call. This
feature is useful for ensuring available resources for new calls,
by ensuring calls are properly terminated.
The valid range is 0 to 35,791, where 0 is unlimited duration.
The default is 0.
configure voip > sip-definition
settings > mn-call-duration
[MinCallDuration]
Defines the minimum call duration (in seconds) for the Tel
side. If an established call is terminated by the IP side before
this duration expires, the device terminates the call with the IP
side, but delays the termination toward the Tel side until this
timeout expires.
The valid value range is 0 to 10 seconds, where 0 (default)
disables this feature.
For example: assume the minimum call duration is set to 10
seconds and an IP phone hangs up a call established with a
BRI phone after 2 seconds. As the call duration is less than
the minimum call duration, the device does not disconnect the
call on the Tel side. However, it sends a SIP 200 OK
immediately upon receipt of the BYE to disconnect from the IP
phone. The call is disconnected from the Tel side only when
the call duration is greater than or equal to the minimum call
duration.
Note:
 The parameter is applicable to IP-to-Tel and Tel-to-IP calls.
 The parameter is applicable only to ISDN and CAS
protocols.
Disconnect on Dial Tone
configure voip > gateway analog fxo-
setting > disc-on-dial-tone
[DisconnectOnDialTone]
Determines whether the device disconnects a call when a dial
tone is detected from the PBX.
 [0] Disable = (Default) Call is not released.
 [1] Enable = Call is released if a dial tone is detected on
the device's FXO port.
Note:
 The parameter is applicable only to FXO interfaces.
 This option is in addition to the mechanism that
disconnects a call when either busy or reorder tones are
detected.
Send Digit Pattern on Connect
configure voip > sip-definition
Defines a digit pattern to send to the Tel side after a SIP 200
OK is received from the IP side. The digit pattern is a user-
To Next Page
Loading...
Need help?
General
