Version 7.2 1137 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
number isn't listed in the table or a call restriction routing rule
of IP address 0.0.0.0 is applied), the call is released.
Note: When no proxy is used, the parameter must be disabled
and filtering is according to the Tel-to-IP Routing table.
IP-to-Tel Tagging Destination Dial
Plan Index
configure voip > gateway routing
settings > ip2tel-tagging-dst
[IP2TelTaggingDestDialPlanIndex]
Defines the Dial Plan index in the Dial Plan file for called prefix
tags for representing called number prefixes in Inbound
Routing rules.
The valid values are 0 to 7, where 0 denotes PLAN1, 1
denotes PLAN2, and so on. The default is -1 (i.e., no dial plan
file used).
For more information on this feature, see Dial Plan Prefix Tags
for IP-to-Tel Routing on page 749.
Note: The parameter is applicable only to digital interfaces.
IP to Tel Tagging Source Dial Plan
Index
cconfigure voip > gateway routing
settings > ip-to-tel-tagging-src
[IP2TelTaggingSourceDialPlanIndex]
Defines the Dial Plan index in the Dial Plan file for calling
prefix tags for representing calling number prefixes in Inbound
Routing rules.
The valid values are 0 to 7, where 0 denotes PLAN1, 1
denotes PLAN2, and so on. The default is -1 (i.e., no dial plan
file used).
For more information on this feature, see Di
for IP-to-Tel Routing on page 749.
Note: The parameter is applicable only to digital interfaces.
etsi-diversion
[EnableETSIDiversion]
Determines the method in which the Redirect Number is sent
to the Tel side.
 [0] = (Default) Q.931 Redirecting Number Information
Element (IE).
 [1] = ETSI DivertingLegInformation2 in a Facility IE.
Add CIC
configure voip > gateway
manipulation settings > add-cic
[AddCicAsPrefix]
Determines whether to add the Carrier Identification Code
(CIC) as a prefix to the destination phone number for IP-to-Tel
calls. When the parameter is enabled, the 'cic' parameter in
the incoming SIP INVITE can be used for IP-to-Tel routing
decisions. It routes the call to the appropriate Trunk Group
based on the parameter's value.
 [0] No (default)
 [1] Yes
For digital interfaces: The SIP 'cic' parameter enables the
transmission of the 'cic' parameter from the SIP network to the
ISDN. The 'cic' parameter is a three- or four-digit code used in
routing tables to identify the network that serves the remote
user when a call is routed over many different networks. The
'cic' parameter is carried in the SIP INVITE and maps to the
ISDN Transit Network Selection Information Element (TNS IE)
in the outgoing ISDN Setup message (if the EnableCIC
parameter is set to 1). The TNS IE identifies the requested
transportation networks and allows different providers equal
access support, based on customer choice.
For example, as a result of receiving the below INVITE, the
destination number after number manipulation is
cic+167895550001:
To Next Page
Loading...
Need help?
General
