User's Manual 1146 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
manipulation settings > ip2tel-
redir-reason
[SetIp2TelRedirectReason]
information is received from the IP, the redirect reason is set to the
value of the parameter before the device sends it on to the Tel.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Note: The parameter is applicable only to digital interfaces.
Set Tel-to-IP Redirect Reason
configure voip > gateway
manipulation settings > tel2ip-
redir-reason
[SetTel2IpRedirectReason]
Defines the redirect reason for Tel-to-IP calls. If redirect (diversion)
information is received from the Tel, the redirect reason is set to
the value of the parameter before the device sends it on to the IP.
 [-1] Not Configured (default)
 [0] Unkown
 [1] Busy
 [2] No Reply
 [3] Network Busy
 [4] Deflection
 [9] DTE out of Order
 [10] Forwarding DTE
 [13] Transfer
 [14] PickUp
 [15] Systematic/Unconditional
Note: The parameter is applicable only to digital interfaces.
Send Screening Indicator to IP
[ScreeningInd2IP]
Overrides the calling party's number (CPN) screening indication in
the received ISDN SETUP message for Tel-to-IP calls.
 [-1] Not Configured = (Default) Not configured (interworking
from ISDN to IP) or set to 0 for CAS.
 [0] User Provided = CPN set by user, but not screened
(verified).
 [1] User Passed = CPN set by user, verified and passed.
 [2] User Failed = CPN set by user, and verification failed.
 [3] Network Provided = CPN set by network.
Note:
 The parameter is applicable only if the Remote Party ID (RPID)
header is enabled.
 The parameter is applicable only to digital interfaces.
Send Screening Indicator to
ISDN
[ScreeningInd2ISDN]
Overrides the screening indicator of the calling party's number for
IP-to-Tel ISDN calls.
 [-1] Not Configured = (Default) Not configured (interworking
from IP to ISDN).
 [0] User Provided = user provided, not screened.
 [1] User Passed = user provided, verified and passed.
To Next Page
Loading...
Need help?
General
