User's Manual 1148 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
routing settings > trkgrpid-prefix
[AddTrunkGroupAsPrefix]

[0] No = (Default) Don't add Trunk Group ID as prefix.
 [1] Yes = Add Trunk Group ID as prefix to called number.
Note:
 This option can be used to define various routing rules.
 To use this feature, you must configure the Trunk Group IDs
(see Configuring Trunk Groups on page 465).
Add Trunk ID as Prefix
configure voip > gateway
routing settings > trk-id-as-
prefix
[AddPortAsPrefix]
Defines if the slot number/port number/Trunk ID is added as a
prefix to the called (destination) number for Tel-to-IP calls.
 [0] No (Default)
 [1] Yes
If enabled, the device adds the following prefix to the called phone
number: slot number (a single digit in the range of 1 to 6) and port
number/Trunk ID (single digit in the range 1 to 8). For example, for
the first trunk/channel located in the first slot, the number "11" is
added as the prefix.
This option can be used to define various routing rules.
Add Trunk Group ID as Prefix to
Source
trkgrpid-pref2source
[AddTrunkGroupAsPrefixToSou
rce]
Determines whether the device adds the Trunk Group ID (from
where the call originated) as the prefix to the calling number (i.e.
source number).
 [0] No (default)
 [1] Yes
Replace Empty Destination with
B-channel Phone Number
configure voip > gateway
routing settings > empty-dst-w-
bch-nb
[ReplaceEmptyDstWithPortNum
ber]
Determines whether the internal channel number is used as the
destination number if the called number is missing.
 [0] No (default)
 [1] Yes
Note:
 The parameter is applicable only to Tel-to-IP calls and if the
called number is missing.
 The parameter is applicable only to digital interfaces.
[CopyDestOnEmptySource] Determines whether the destination number is copied to the source
number if no source number is present, for Tel-to-IP calls.
 [0] = (Default) Source Number is left empty.
 [1] = If the Source Number of a Tel-to-IP call is empty, the
Destination Number is copied to the Source Number.
Note: The parameter is applicable only to digital interfaces.
Add NPI and TON to Calling
Number
configure voip > gateway
routing settings > npi-n-ton-to-
cng-nb
[AddNPIandTON2CallingNumb
er]
Determines whether the Numbering Plan Indicator (NPI) and Type
of Numbering (TON) are added to the Calling Number for Tel-to-IP
calls.
 [0] No = (Default) Do not change the Calling Number.
 [1] Yes = Add NPI and TON to the Calling Number ISDN Tel-to-
IP call.
For example: After receiving a Calling Number of 555, NPI of 1,
and TON of 3, the modified number becomes 13555. This number
can later be used for manipulation and routing.
Note: The parameter is applicable only to digital interfaces.
Add NPI and TON to Called
Number
Determines whether NPI and TON are added to the Called Number
for Tel-to-IP calls.
To Next Page
Loading...
Need help?
General
