AudioCodes MSBG Series User Manual

Version 7.2 1179 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
RADIUS Response Time
Out
[RadiusTO]
Defines the time interval (in seconds) that the device waits for a
response before it performs a RADIUS retransmission. See also the
RADIUSRetransmission parameter.
The valid range is 1 to 30. The default is 10.
RADIUS Accounting Parameters
RADIUS Accounting Type
configure voip > sip-
definition settings > radius-
accounting
[RADIUSAccountingType]
Defines at what stage of the call that RADIUS accounting messages
are sent to the RADIUS accounting server.
 [0] At Call Release = (Default) Sent at call release only.
 [1] At Connect & Release = Sent at call connect and release.

[2]
At Setup & Release = Sent at call setup and release.
AAA Indications
configure system > cdr >
aaa-indications
[AAAIndications]
Enables the Authentication, Authorization and Accounting (AAA)
indications.
 [0] None = (Default) No indications.
 [3] Accounting Only = Only accounting indications are used.
RADIUS User Authentication Parameters
Use RADIUS for
Web/Telnet Login
configure system > radius
settings > enable-mgmt-
login
[WebRADIUSLogin]
Enables RADIUS queries for Web and Telnet login authentication.
When enabled, logging into the device's Web and Telnet embedded
servers is done through a RADIUS server. The device communicates
with a user-defined RADIUS server and verifies the given username
and password against a remote database in a secure manner.
 [0] Disable (default)
 [1] Enable
Note:
 For RADIUS login authentication to function, you must also
configure the EnableRADIUS parameter to 1 (Enable).
 RADIUS authentication requires HTTP basic authentication, where
the username and password are transmitted in clear text over the
network. Therefore, it's recommended to set the HTTPSOnly
parameter to 1 to force the use of HTTPS, since the transport is
encrypted.
Password Local Cache
Mode
configure system > radius
settings > local-cache-mode
[RadiusLocalCacheMode]
Defines the device's mode of operation regarding the timer (configured
by the parameter RadiusLocalCacheTimeout) that determines the
validity of the username and password (verified by the RADIUS
server).
 [0] Absolute Expiry Timer = When you access a Web page, the
timeout doesn't reset, instead it continues decreasing.
 [1] Reset Timer Upon Access = (Default) Upon each access to a
Web page, the timeout always resets (reverts to the initial value
configured by RadiusLocalCacheTimeout).
Password Local Cache
Timeout
configure system > radius
settings > local-cache-
timeout
[RadiusLocalCacheTimeout]
Defines the time (in seconds) the locally stored username and
password (verified by the RADIUS server) are valid. When this time
expires, the username and password become invalid and a must be re-
verified with the RADIUS server.
The valid range is 1 to 0xFFFFFF. The default is 300 (5 minutes).
 [-1] = Never expires.
 [0] = Each request requires RADIUS authentication.

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English