Version 7.2 343 Mediant 1000B Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
Keep Original Call-ID
sbc-keep-call-id
[IPGroup_SBCKeepOriginal
CallID]
Enables the device to use the same call identification (SIP Call-ID
header value) received in incoming messages for the call identification
in outgoing messages. The call identification value is contained in the
SIP Call-ID header.
 [0] No = (Default) The device creates a new Call-ID value for the
outgoing message.
 [1] Yes = The device uses the same Call-ID value received in the
incoming message for the Call-ID in the outgoing message.
Note: When the device sends an INVITE as a result of a REFER/3xx
termination, the device always creates a new Call-ID value and
ignores the parameter's settings.
Dial Plan
sbc-dial-plan-name
[IPGroup_SBCDialPlanNam
e]
Assigns a Dial Plan to the IP Group. The device searches the Dial
Plan for a dial plan rule that matches the source number and if not
found, for a rule that matches the destination number. If a matching
dial plan rule is found, the rule's tag is used in the routing and/or
manipulation processes as source and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans on page 689.
Call Setup Rules Set ID
call-setup-rules-set-id
[IPGroup_CallSetupRulesSe
tId]
Assigns a Call Setup Rule Set ID to the IP Group. The device runs the
Call Setup rule immediately before the routing stage (i.e., only after the
classification and manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see Configuring Call Setup Rules on
page 377.
Quality of Experience
QoE Profile
qoe-profile
[IPGroup_QOEProfile]
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
To configure Quality of Experience Profiles, see ''Configuring Quality
of Experience Profiles'' on page 297.
Bandwidth Profile
bandwidth-profile
[IPGroup_BWProfile]
Assigns a Bandwidth Profile rule.
By default, no value is defined.
To configure Bandwidth Profiles, see ''Configuring Bandwidth Profiles''
on page 302.
Message Manipulation
Inbound Message
Manipulation Set
inbound-mesg-manipulation-
set
[IPGroup_InboundManSet]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the inbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see Configuring SIP
Message Manipulation on page 368.
Note:
 The parameter is applicable only to the SBC application.
 The IPGroup_SIPGroupName parameter overrides inbound
message manipulation rules (assigned to the
IPGroup_InboundManSet parameter) that manipulate the host
name in Request-URI, To, and/or From SIP headers. If you want to
manipulate the host name using messag
e manipulation rules in any
of these SIP headers, you must apply your manipulation rule
(Manipulation Set ID) to the IP Group as an Outbound Message
To Next Page
Loading...
Need help?
General
