Version 7.2 345 Mediant 1000B Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
username and password) according to one of the following:
1)Account configured in the Accounts table (only if authenticating
Server-type IP Group), 2) global username and password
parameters (only if authenticating Server-type IP Group), 3) User
Information file, or 4) sends request to users requesting credentials
(only if authenticating User-type IP Group). For more information
on Accounts, see Configuring Registration Accounts on page
361.
 [2] SBC as Server = The device acts as an Authentication server:
Authenticates SIP clients, using the usernames and passwords
in the User Information table (see SBC User Information for
SBC User Database on page
759). This is applicable only to
User-type IP Groups.
Authenticates SIP severs. This is applicable only to Server-
Authentication Method List
authentication-method-list
[IPGroup_MethodList]
Defines SIP methods received from the IP Group that must be
challenged by the device when the device acts as an Authentication
server. If no methods are configured, the device doesn't challenge any
methods.
By default, no value is defined. To define multiple SIP methods, use
the backslash ( \ ) to separate each method (e.g., INVITE\REGISTER).
Note: The parameter is applicable only if the 'Authentication Mode'
parameter is set to SBC as Server [2].

Username
username
[IPGroup_Username]
Defines the shared username for authenticating the IP Group, when
the device acts as an Authentication server.
The valid value is a string of up to 51 characters. By default, no
username is defined.
Note:
 The parameter is applicable only to Server-type IP Groups and
when the 'Authentication Mode' parameter is set to SBC as Server
(i.e., authentication of servers).
 To specify the SIP request types (e.g., INVITE) that must be
challenged by the device, use the 'Authentication Method List'
parameter.
Password
password
IPGroup_Password]
Defines the shared password for authenticating the IP Group, when
the device acts as an Authentication server.
The valid value is a string of up to 51 characters. By default, no
password is defined.
Note:
 The parameter is applicable only to Server-type IP Groups and
when the 'Authentication Mode' parameter is set to SBC as Server
(i.e., authentication of servers).
 To specify the SIP request types (e.g., INVITE) that must be
challenged by the device, use the 'Authentication Method List'
parameter.
Gateway
SIP Re-Routing Mode
re-routing-mode
Defines the routing mode after a call redirection (i.e., a 3xx SIP
response is received) or transfer (i.e., a SIP REFER request is
received).
To Next Page
Loading...
Need help?
General
