User's Manual 468 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
3. Configure a Trunk Group according to the parameters described in the table below.
4. Click Apply.
Table 22-2: Trunk Group Settings Table Parameter Descriptions
Parameter Description
General
Index
[TrunkGroupSettings_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
trunk-group-name
[TrunkGroupSettings_TrunkGro
upName]
Defines an arbitrary name to easily identify the row.
The valid value can be a string of up to 40 characters. By default,
no name is configured.
The name also represents the Trunk Group in the SIP 'tgrp'
parameter in outgoing INVITE messages (according to RFC 4904)
if the UseSIPtgrp or UseBroadsoftDTG parameter is enabled. For
example, if you configure the parameter to "ITSP-ABC":
sip:+16305550100;tgrp=ITSP-ABC;trunk-
context=+1-630@isp.example.net;user=phone
If the parameter is not configured, the Trunk Group number is used
in the 'tgrp' parameter, for example:
sip:+16305550100;tgrp=TG-1;trunk-context=+1-
630@isp.example.net;user=phone
Note: Each row must be configured with a unique name.
Trunk Group ID
trunk-group-id
[TrunkGroupSettings_TrunkGro
upId]
Defines the Trunk Group ID that you want to configure.
To Next Page
Loading...
Need help?
General
