PLC Error Codes for Omron FINS
Panel Error Code
P499 Hex Value
Description
0x1104 Parameter Error: Address range exceeded.
0x1106 Parameter Error: Program Missing.
0x1109 Parameter Error: Relational Error.
0x110A Parameter Error: Duplicate Data Access.
0x110B Parameter Error: Response too long.
0x110C Parameter Error: Parameter Error.
0x2002 Read Not Possible: Protected.
0x2003 Read Not Possible: Table missing.
0x2004 Read Not Possible: Data missing.
0x2005 Read Not Possible: Program missing.
0x2006 Read Not Possible: File missing.
0x2007 Read Not Possible: Data mismatch.
0x2101 Write Not Possible: Read Only.
0x2102 Write Not Possible: Protected - cannot write data link table.
0x2103 Write Not Possible: Cannot register.
0x2105 Write Not Possible: Program missing.
0x2106 Write Not Possible: File missing.
0x2107 Write Not Possible: File name already exists.
0x2108 Write Not Possible: Cannot change.
0x2201 Not executable in current mode: Not possible during execution.
0x2202 Not executable in current mode: Not possible while running.
0x2203 Not executable in current mode: Wrong PLC mode (Program).
0x2204 Not executable in current mode: Wrong PLC mode (Debug).
0x2205 Not executable in current mode: Wrong PLC mode (Monitor).
0x2206 Not executable in current mode: Wrong PLC mode (Run).
0x2207 Not executable in current mode: Specified node not polling node.
0x2208 Not executable in current mode: Step cannot be executed.
0x2301 No such device: File device missing.
0x2302 No such device: Missing memory.
0x2303 No such device: Clock missing.
0x2401 Cannot Start/Stop: Table missing.
0x2502 Unit Error: Memory Error.
0x2503 Unit Error: I/O setting Error.
0x2504 Unit Error: Too many I/O points.
0x2505 Unit Error: CPU bus error.
0x2506 Unit Error: I/O Duplication.
To Next Page
Loading...
Need help?
General