Chemical Compatibility
The C-more Micro-Graphic panels are built of three different materials that may be exposed to
elements outside of the enclosure. The panel’s screen has a polyester (PET) surface. The bezel
uses ABS plastic materials and the panel’s gasket is a silicone rubber material. The following
tables are provided to make you aware of the general compatibility between chemicals that may
be present in your work environment and the various materials used in the manufacture of the
panel. Use the table to determine those chemicals that are safe to use around your C-more
Micro-Graphic panel and those that may harm it. The tables are made up of specifications
provided by the manufacturer of the listed material. The tables rate these chemicals as either
Excellent, Good, Not Recommended, or Not Usable. Because the ratings are for ideal
conditions at room temperature, consider all factors when evaluating your application. Areas left
blank have not been tested by the manufacturer of the materials and therefore information of
compatibility is not available.
Table continued at top of next page.
2–10
Chapter 2: Specifications
2
EA1-TCL-M Hardware User Manual, 2nd Ed., 10/10
Chemicals
Screen Sheet – PC
[Density %,
Temperature °C]
Bezel – ABS
[Density %,
Temperature °C]
Gasket – Silicone
[Density %,
Temperature °C]
Bezel Key Sheet –
PET
[Density %,
Temperature °C]
Acetaldehyde
Not Recommended
Acetic Acid
[10, 20 °C] Excellent
[10, 20 °C] Excellent
[50, 20 °C] Not Usable
[50-70, 20 °C] Not Usable
[100, 20 °C] Not Usable
Acetic anhydride
Not Recommended
Acetone
Not Usable Not Usable Excellent
Acetophenone
Not Usable
Acetylene
Excellent
Acrylonitrile
Not Recommended
Alcohol - Butyl Ether
Excellent
Alcohol - Ethanol
Excellent
Alcohol - Isopropyl
Excellent
Alums NH3, Cr, K
Excellent
Aluminum acetate
Excellent
Aluminum bromide
Good
Aluminum chloride
Good
Aluminum nitrate
Excellent
Aluminum sulfate
Excellent
Ammonia [anhydrous]
Good
Ammonia gas [cold]
Good
To Next Page
Loading...
Need help?
General