Optimal Huddle Room Setup
For a typical huddle room, up to 3m x 3m and with up to 3-4 people attending the conference, a
CU360 device placed on top of a 1080p or 4K monitor provides the best experience. The audio
captured from the embedded device’s mics is enough, and the monitor provides the audio output
through HDMI. The camera can be adjusted manually to focus on the person in front of it and then
can be digitally panned and tilted once zoomed in.
Important
• To use the speaker tracking feature of the camera, please assure that the camera is not
panned left or right but is kept centered in horizontal. The camera can be tilted up or
down.
To zoom in/out the camera, use the remote-control, or browse to Control Camera menu in the
CU360 App, press zoom in (+) and then move the camera with the arrows on the remote-control
or on the app UX.
Figure 6: CU360 Device Typical Placement
Figure 7: Huddle Room Setup with CU360
Important
• Do not pan the camera manually (left or right) if you want to use the camera speaker-
tracking feature.
Controlling Your Device
The device can be controlled from the default remote-control and from any standard control
device, such as keyboard/mouse and touch screen, compatible with Android (no driver required).
See below sections for details.
The following Apps are also available for smartphones and tablets:
- Avaya Collaboration Control for iPhone and iPad (available on the Apple Store), providing
the same experience as for XT Series devices. You can download the App from
https://apps.apple.com/us/app/scopia-control/id403154133.
- Avaya Collaboration control for Avaya Vantage (K165/K175) and Android smartphones.
Collaboration Control is available now on Google Play Store™ at
https://play.google.com/store/apps/details?id=com.avaya.avayacollaborationcontrol&hl=en
(Play Store is a trademark of Google LLC).
Using the CU360 Remote-control
The remote-control provided inside the box is already paired, just plug in the provided batteries.
If the remote-control is not pre-paired with your CU360 codec unit, you need to do the following:
• Assure that the remote-control is equipped with 2 AAA charged batteries.
• Unplug the codec unit from power.
• Press the Back key and the OK key together, until the small blue LED on top of the remote
quickly flashes a few times.
• While the LED light is still flashing, plug the codec unit into power while keeping the
remote-control close to the unit. The remote-control led should stop flashing to show
successful pair.
To Next Page
Loading...
