Figure 35: USB A/V Bar Mode Always Active - Disabled on Exit
Quick Recap of USB A/V Bar Mode
Once CU360 has been configured to work as USB A/V Bar in Manual mode or in Always Active
mode, this is the behavior of the device.
• Manual Mode (default): connect the computer and press the toggle USB Bar mode key
on the remote-control (or the GUI/Web corresponding menu) to use the CU360 in A/V Bar
mode. Press the same remote-control key to exit A/V Bar mode and to resume the usual
functionalities of the device.
• Always Active Mode: connect the computer to use the CU360 in A/V Bar mode. Press
Exit to disable Always Active Mode from the configuration.
• Control Camera in Bar Mode
o Pan/Tilt/Zoom
- To zoom in/out, use the zoom keys on the remote-control
- To pan/tilt, first use the zoom-in key, then press the air pointer key
on the remote-control (the small light on the top right of the remote-control
becomes steady blue), and drag the video image while pressing the
key.
-
o Tracking Mode
- Change camera tracking mode (Track Speaker/Auto Framing/Tracking
Off), by pressing the key (when a tracking mode is active, ePTZ is
disabled).
o Virtual Background
- Change camera background mode (real background, blurred background
and virtual background) by pressing the key on the remote-control.
• Speaker Volume in Bar Mode:
o To change CU360 current speakers’ volume (embedded speakers or audio
peripherals), you can use both the computer volume controls and the CU360
volume keys on the remote-control. If you cannot hear audio out, please
check both computer volume and CU360/peripherals volume.
• Mute Mic in Bar Mode:
o To mute the CU360 microphone, use the functionalities of the application on the
computer.
To Next Page
Loading...
