Figure 2: Login to the CU360 Web Interface
Important
• See the Known Issue section for a limitation about using the web interface with iOS
mobile devices.
Important
• You need to press the 'Save' button to apply changes done to a configuration via the web
interface, otherwise your changes will not be applied.
Figure 3: Press Save to Change Settings in the Web Interface
Important
• The Web Server for the CU360 unit is implemented by an application named jsweb which
is automatically launched at system start-up. Do not terminate the app.
Connecting the Unit and Quick Setup
Please refer to the quick setup guide for a detailed setup description in a standard huddle room
scenario.
Figure 4: CU360 Unboxing
Figure 5: CU360 Device Setup
• Place the CU360 above your TV, and use the hinge to secure it.
• Plug the HDMI cable into the TV and CU360.
• Connect a LAN / Ethernet cable (or you can configure a Wi-Fi network later). A PoE
Splitter accessory, not included in the box, is available. See the support site.
• To connect a second display to CU360, please use only a qualified powered USB Type-C
to HDMI adapter, see the support site.
• Plug in the CU360 power adapter.
• Use the rubber cap to cover the camera for privacy.
Power On/Off the Unit
• [ON THE DEVICE] Hold the power button on the back of the unit to switch on/off the system.
• [ON THE DEVICE] Quickly press the power button on the back of the unit to put in standby the system
or to wake it up.
• [ON THE DEVICE] Do not unplug/shutdown the power to turn the system off, especially when the
device is in a call.
• [ON THE REMOTE-CONTROL] Long press the 'Power' key to power-on the device, until you see the LEDs
around the camera alight.
• [ON THE REMOTE-CONTROL] Long press the 'Power' key to power-off the device, until you see the
“Power off/Restart/Screenshot menu”. Activate the mouse pointer on the remote-control and
select “Power off”.
To Next Page
Loading...
