Figure 62: Switching between Overlay and Fullscreen Modes
How to Start the CU360 Application
By default, the CU360 App starts maximized (Full Screen) every time the device is booted up.
You can change the start mode of the application or decide that a different application must be
automatically launched when CU360 starts.
CU360 App Configurable Start Mode
You can configure the CU360 App to start in several ways
[GUI] CONFIGURE > ADVANCED > SYSTEM > CUSTOMIZATION
[WEB] [ADMIN LOGIN] ADMINISTRATOR SETTINGS> SYSTEM > CUSTOMIZATION >
• Start Mode:
o Full Screen*: the CU360 app starts and shows its UX full screen (or in the
available space if the screen is split)
o Iconized: the CU360 app starts minimized. A floating icon is visible on the
screen When this option is active, Kiosk/Restricted mode is disabled (and the
reverse)
o Hidden: the CU360 app starts without any visible floating icon on the screen.
When this option is active, Kiosk/Restricted mode is disabled (and the
reverse) [2].
o Iconized starting application: same as Iconized, but also launching an
additional application you can choose from a list of installed apps [1].
o Hidden starting application: same as Hidden, but also launching an additional
application you can choose from a list of installed apps [1].
• Application to Start: additional application to start that you can choose from a from a list of
installed apps [1].
Figure 63: Application Start Mode
Important
• [1] The app to launch cannot be chosen through the Web interface in this release.
• [2] When configured as hidden, the CU360 app will not react to any event (ScreenLink
connections, Avaya AVGrabber plugged, calendar events, …). Only incoming calls and
software upgrades initiated remotely will automatically restore the app to foreground.
CU360 App Floating Dock Bar
When the CU360 App is in the foreground (has the focus), a floating dock bar is accessible in any
page for common actions and to navigate to previous pages. When in a call, a hotdog icon (three
lines) in the dock bar can be used to activate the call panel.
The floating dock bar can be moved to a different place on the screen, docked to a side or with a
free position. The last position of the floating bar is restored when the app restarts (unless the app
is restored to factory settings)
In this release, a disconnect icon is available on the floating bar to quickly disconnect a call.
To Next Page
Loading...
