Configure the CU360 for USB Audio/Video Bar Mode
USB Audio/Video Bar Mode can be activated manually on CU360, once a connected computer is
detected. The CU360 can also be configured to keep USB Bar mode always active in the initial
Quick Setup Wizard, or by configuration.
Important
• If you plan to use the CU360 only in USB A/V Bar Mode, without connecting any
monitor to it, it is strongly suggested to configure the CU360 Bar Mode as
“Always Active”.
To configure CU360 with USB Bar Mode always active from the Quick Setup Wizard, go to
[GUI] CONFIGURE > QUICK SETUP>
[WEB] [ADMIN LOGIN]BASIC SETTINGS> QUICK SETUP>
And select “As USB Audio/Video Bar”.
Figure 18: Configure USB A/V Bar mode “Always Active” in the Quick Setup
To change CU360 USB Bar Mode configuration from the Settings, you can also go to
[GUI] CONFIGURE > CUSTOMIZATION>
[WEB] [ADMIN LOGIN] ADMINISTRATOR SETTINGS> SYSTEM > CUSTOMIZATION >
• USB Bar Mode: Manual*/Always active.
o Manual: once the computer connected to the CU360 via USB is detected, you
can activate USB Bar mode via the remote-control or the web interface.
o Always Active: just connect your computer to the CU360 via USB to start
using the CU360’s audio/video peripherals from your computer. No further
manual interaction or activation is required.
Figure 19: Configure USB A/V Bar mode “Always Active” from Settings
Important
• While the USB Bar Mode is active (for manual activation or persistent “always
active” configuration) all the other functionalities of the device from the Web and
the GUI interface are disabled.
o Incoming call will be automatically rejected (Do not disturb mode) and
calendar meeting notifications are silenced.
o From the GUI and the Web interface you can only turn-off USB A/V Bar
Mode.
o You can still upgrade the device via PC or Avaya Management.
Activate USB A/V Bar Mode – Manual Mode
In manual mode, once the computer is detected by the CU360, a message will be shown on the
CU360 App page, and an icon will appear on the CU360 App top info-bar. The icon for Control
Camera will also change.
Figure 20: Computer connected via USB 3.0 to CU360 – USB Bar Mode is Manual
To activate USB Bar mode, once your computer has been detected, press the Control camera
button on the system UX (GUI or web) or the proper remote-control key (see below pictures).
To Next Page
Loading...
