Avaya CU360 - Page 26

© 2021 Avaya Inc. All rights reserved
Release Notes for Avaya Collaboration Unit CU360 Beta Build Limitation 26
Figure 21: How to Activate USB A/V Bar Mode – GUI
Figure 22: How to Activate USB A/V Bar Mode – Remote-control Key
Figure 23: How to Activate USB A/V Bar Mode – Web
Important
• If you plan to use the CU360 in USB Bar Mode only, without connecting any
monitor to it, it is strongly suggested to configure the CU360 Bar Mode as
“Always Active”.Once USB Bar mode is active and the computer is
connected, the LEDs around CU360 camera will become green.
Figure 24: USB A/V Bar Mode Active and computer connected – Green LEDs around the Embedded Camera
Figure 25: USB A/V Bar Mode Active and Computer Connected - GUI
Figure 26: USB A/V Bar Mode Active and Computer Connected – Web
Incoming call will be automatically rejected (Do not disturb mode) and calendar meeting
notifications are silenced. From the GUI and the Web interface you can only turn-off USB A/V Bar
Mode.
Activate USB A/V Bar Mode – Always Active
In “Always Active” mode, the CU360 is ready to detect a computer connected via USB and to
activate USB Bar mode automatically.
The CU360 will show this page waiting for a computer to connect.
Figure 27: USB A/V Bar Mode Active – Prompt to connect a computer – GUI&Web
Once USB Bar mode is active and the computer is connected, the LEDs around CU360
camera will become green and the CU360‘s GUI or Web interface will show below pages.
Figure 28: USB A/V Bar Mode Active and computer connected – Green LEDs around the Embedded Camera
Figure 29: USB A/V Bar Mode Active and Computer Connected – GUI&Web
If you press Exit, the device will ask confirmation to disable the “Always Active” mode.
If you unplug the USB cable (from CU360 or computer), the device will remain in Always Active
mode and prompt the user to connect the computer again.
Use CU360 Audio/Video resources on the Computer
Once the USB Bar mode is active and the computer is connected (green light on the CU360), you
can use the CU360 embedded camera, microphones, and speakers as USB resources in any
unified communication or media application running on the computer.
Important
• If there are additional audio in/out resources connected to the CU360 once USB
Bar Mode is activated, they will be used by default in place of the embedded
mics/speakers. In particular, the device will apply this order for available audio
paths: BT audio headsets/speakerphones connected to CU360USB audio
headsets/speakerphones connected to CU360Speakers of HDMI monitors
connected to CU360 and embedded mic arrayCU360 Embedded speakers and