Avaya CU360 - Page 27

© 2021 Avaya Inc. All rights reserved
Release Notes for Avaya Collaboration Unit CU360 Beta Build Limitation 27
embedded mic arrayAudio flow may not behave as expected in event of hot
connection / disconnection of BT or USB devices while the CU360 is in USB Bar
Mode.If there are additional video cameras (USB or IP) connected to the CU360
once USB Bar Mode is activated, they will NOT be used. The embedded camera
is automatically selected in AV Bar Mode. USB A/V Bar Mode Active – Select as
USB Camera/Microphone/Speaker in Spaces
While the USB Bar Mode is active, the CU360 remote-control can be used to zoom/in out the
camera, and to PAN/TILT or activate the speaker tracking.
- To zoom in/out, use the zoom keys
- To pan/tilt, first use the zoom-in key, then activate the air pointer on the
remote-control (the small light on the top right of the remote control
becomes steady blue), and drag the video image while pressing the
key.
- To toggle the speaker tracking feature, press the key (when
speaker tracking is active, ePTZ is disabled).
To mute the CU360, use the functionalities of the application on the computer
To change CU360 speakers’ volume, you can use both the computer volume controls and the
CU360 volume keys on the remote-control. If you cannot hear audio out of the CU360 (embedded
speakers or audio peripherals) please check both computer volume and CU360/peripherals
volume.
You can test the audio volume on the CU360 before activating USB Bar mode in this way:
[GUI]CONFIGURE> SYSTEM STATUS>DIAGNOSTICS>I/O CONNECTIONS>AUDIO>TES TS> LOCAL TONE
Increase the audio volume using CU360 remote-control, and also check volume on connected
audio peripherals (HDMI TV with own audio level, BT/USB audio devices).
Figure 31: Check Audio Level on CU360 Audio-out
Deactivate USB A/V Bar Mode
When USB bar mode is active, the LEDs around the embedded camera are green and the
UX/Web interface of the device only allow to deactivate USB Bar Mode.
Figure 32: USB A/V Bar Mode Active – Green LEDs around the Embedded Camera
Figure 33: USB A/V Bar Mode Active – UX
Figure 34: USB A/V Bar Mode Active – Web
The remote-control key can be used to easily stop USB Bar Mode even when the CU360 is
not connected to a monitor. As an alternative, press on the Exit buttons on the UX/Web interface.
If the A/V bar mode was configured in “Always Active” Mode, exiting from the page will ask a
confirmation to disable the “Always Active” mode.