Avaya CU360 - Camera Tracking Modes

© 2021 Avaya Inc. All rights reserved
Release Notes for Avaya Collaboration Unit CU360 Avaya CU360 Setup and Control 17
• When using the CU360 App, you can simultaneously move the far camera and the
local camera
o Toggle far/near to select “Far Camera”. Move far camera using the arrows in
the remote-control.
o Activate the mouse pointer with the key and long press the key
while moving the mouse pointer to move the camera. Camera must be
zoomed in.
• The CU360 App will restore its latest used PTZ position, discarding the movements
done while using other apps.
• See also Control Camera for Third-Party Apps
Camera’s and Front LEDS
The CU360 device is equipped with two rows of front LEDs on the side of the camera and with a
circular crown of LEDS around the camera lens.
Those LEDS will change color or add animation effects in the different conditions, when the
CU360 App is in foreground or in a call or while streaming.
Table 1: LED Colors
Condition
Circle LED Color
Circle LED Effect
Lateral Led strips
Alarms (for instance no IP address
assigned)
Red
Red
Idle
Yellow
Idle, Mute/System Sleep
Blue
Blue
USB bar mode active
Green
In a call/streaming
Green
In a call/streaming, Mute
Blue
Blinking
Blue
In a call/streaming, Privacy
Green (Blue if Audio mute)
Red
Firmware upgrade in progress or
incoming/outgoing call establishing
Red
Rotating
Red
Camera Tracking Modes
The CU360 camera tracking feature helps directing the meeting in intelligent way, focusing on the
active speaker in the room (Track Speaker, also called Speaker-Tracking) or automatically framing
a group of people in the room (Auto-Framing, also called Group Framing ).
The embedded HD camera can be configured to work in two different “Tracking Modes” when the
CU360 App is in foreground or in overlay (while in a call) and no other app is using the camera.
In the CU360 App, you can press the “Enable/Disable tracking camera” key on the remote-control
to toggle on/off the current tracking mode functionality of the camera on the fly (default is off ,
Track Speaker).
Figure 1: Tracking Mode Key on Remote-Control
The default mode for the CU360 application can be changed at
[GUI] CONFIGURE > ADVANCED > I/O CONNECTIONS>CAMERAS > HD1 >
[WEB] [ADMIN LOGIN] ADMINISTRATOR SETTINGS> I/O CONNECTIONS>CAMERAS > HD1 >