How to store or recall a preset - Web
To store or recall presets positions for the near camera on the device Web interface, go to
[WEB] [ADMIN LOGIN] MORE ACTIONS>CONTROL CAMERA
While in the Cameras Control page, you can zoom in/out the local camera by pressing on the
“plus” and minus” lens icons, and you can pan/tilt the camera using the arrows inside the Move
panel.
Figure 90: Web > More Actions >Cameras Control
You can see the enabled preset in the page, edit or delete presets or store new presets.
You can also choose a default preset. The default preset will be recalled automatically every time
the system restarts.
Figure 91: Web > Cameras Control Presets
From the web interface only, you can store and recall up to 122 presets.
Restricted Access Mode (Pinned Mode)
An advanced setting in the Security Configuration section allows locking the CU360 in "restricted
mode". When the system is in restricted mode, Android features are locked, and the device acts in
“kiosk/pinned mode”, as a pure videoconferencing device. The Advanced Settings are password
covered, accessible only to System Admin.
Note that when restricted mode is active, no other application can be installed or launched ("Apps"
menu is hidden) and Android settings are no longer accessible. In this case the app cannot start
minimized.
To enable Restricted Access, from the GUI interface or the Web interface, browse to
[GUI] CONFIGURE > ADVANCED > [ADMINISTRATOR PIN] > SYSTEM>SECURITY> RESTRICTED ACCESS >
[WEB] [ADMIN LOGIN] ADMINISTRATOR SETTINGS>SYSTEM>SECURITY >RESTRICTED ACCESS>
• Enable = Yes
From this page, the administrator can also configure Bluetooth and Wi-Fi in Android Settings,
which are no longer accessible from the device desktop.
Figure 92: Configuration for Restricted Access (Kiosk/Pinned Mode)
Figure 93: Shortcut to Wi-Fi/Bluetooth Configuration
Important
• In some installations, Wi-Fi and Bluetooth settings could not be visible due
because disabled by a special license.
To Next Page
Loading...
