o Zoom factor of the camera
A camera preset can be stored and recalled for the local (also called embedded or near) camera,
and if the remote party or the meeting supports and enables the Far End Camera Control (FECC)
protocol, also a far preset (camera of the remote party, or the camera of the active speaker in a
meeting) can be recalled and stored.
With CU360, it is possible to store and recall presets for the local (also called near) cameras
(embedded and USB cameras) .
The near camera supports movements and zooming through digital Pan Tilt Zoom (PTZ)
commands, when the Camera tracking feature is not active.
In the GUI, zoom commands (zoom in, zoom out keys ) for the near, or far, camera are available
through the remote-control (or a mouse) when the CU360 app is in foreground, while pan and tilt
commands are available (arrow keys) only in the Control Camera page).
To switch between controlling the near or the far camera, you can also press the Control far/near
camera on the remote-control.
Figure 86: Control Far/Near Camera Key on the Remote-control
PTZ and presets commands for far/near cameras are also available through the Web interface, or
through AT commands.
Presets are available also for an additional USB camera, if Control Camera is enabled.
Figure 87: Enable Control Camera for USB
How to store or recall a preset - GUI
To store or recall presets positions for the near camera on the device graphical user interface
(GUI), go to
[GUI] CONTROL CAMERA> PRESETS>
Figure 88: GUI > Control Camera Panel > Presets Button
While in the Presets page, you can zoom in/out the camera by pressing on the “plus” and minus”
icons, and you can pan/tilt the camera using the arrows. You can also use the remote-control keys
to PTZ the camera while in this page.
Once you move the camera to the desired position, you can save (store) the current position in a
preset. The stored preset can be recalled any time to move again the camera in the saved
position. Assigned presets are visible as numbers within light-blue circles. Not assigned presets
are dark.
Figure 89: GUI > Control Camera Panel > Camera Presets Page
Store a preset using the remote-control keys: press the corresponding number on the remote-
control keyboard. The circle with the number will blink. Pan/tilt/zoom the camera, and press enter
when done. The circle color will become light blue.
Store a preset using a mouse pointer: Adjust the camera, then long click on the circle with the
number you want to reserve for the preset. The circle will become light blue.
Delete an assigned preset using the remote-control keys: press the corresponding number on
the remote-control keyboard. The circle with the number will blink. Press the delete key on the
remote-control to unassign the preset. The circle color will become dark.
Recall a preset using a mouse pointer: Click on the circle with the desired number.
From the GUI, you can assign and recall up to 10 presets.
To Next Page
Loading...
