To change this behavior, you can configure the endpoint to “remember” the favorite layout for
each video combination, per call or always. See “Remember Favorite Layouts” in CU360
documentation.
The monitor scenario setting is available at
[GUI] CONFIGURE > ADVANCED > I/O CONNECTIONS> MONITORS>GENERAL
[WEB] [ADMIN LOGIN] ADMINISTRATOR SETTINGS> I/O CONNECTIONS> MONITORS>GENERAL
• Number of Monitors: Auto*/HD1/HD1(Menu & Present.) + HD2 (Video Rx)
It is strongly suggested to keep the number of monitors to Auto. Do not plug the additional
monitor if you need the device to work with a single monitor.
Figure 16: I/O Connections > Monitors Settings
Important – BETA BUILD
• Do not activate auto-framing when using an additional monitor. The video could
freeze, or the device could hang.
To Next Page
Loading...
