To connect your PC or Mac to the CU360 USB port using the AV grabber, please follow the
instructions below:
• Connect the Computer to be used as presentation source to the HDMI INPUT connector
on the AV Grabber using an HDMI cable (not provided).
• Connect the USB connector on the AV Grabber to USB 3.0 connector on CU360 using the
provided USB cable.
Important!
• If you need to use an USB hub to connect the AV grabber to the CU360, assure
that it 3.0 and properly powered on.
• If the USB hub is not 3.0 or is not properly powered, when the grabber is in use
the device could reset unexpectedly due to excessive power consumption from
the grabber.
Figure 74: Avaya AV Grabber: connection with Computer and CU360
The computer will detect the presence of the grabber as additional monitor. You can duplicate the
desktop of your computer or you can extend it over the additional monitor.
Once the AV Grabber is properly connected to the CU360, the CU360 Video-collaboration
Application will detect the video input coming from the computer through the AVY Grabber as an
additional USB video input, and you can select it as a presentation source (in local presentation
mode or when in a call).
The supported resolutions when the PC/Mac is connected through the HDMI output to the grabber
are the following:
Table 3: Supported Computer Resolutions
Important
• The suggested resolution for the grabber as additional monitor of the computer is 1080p.
Not all the resolutions proposed by the computer are supported. Please check that the
selected resolution is detected by the CU360 application.
• When a resolution is not detected from the grabber (or the computer is in stand-by), a PC
image will be displayed as in the picture in the CU app.
Figure 75: Avaya AV Grabber: Unsupported Resolution or No Signal from Computer
When muting the CU360 App microphone, the audio associated to the AVGrabber can be heard
or transmitted anyway. You can also decide to always hear the audio, or only associated to a
presentation. To change these options, go to
[GUI] CONFIGURE > ADVANCED > SYSTEM > I/O CONNECTIONS> USB CAMERA
[WEB] [ADMIN LOGIN] ADMINISTRATOR SETTINGS> SYSTEM > I/O CONNECTIONS>AUDIO> USB CAMERA
To Next Page
Loading...
