Powering Up and Configuring the System 47
Powering Up and Configuring the System
After installing software and making S6L network connections, follow the instructions in this section install the bezel on the E6L
engine, then learn how to power the system up (and down) and configure your S6L system.
Installing the E6L Bezel
After confirming installation and activation of Windows and RTX, and after mounting the E6L in a rack or other enclosure, you
can install the E6L bezel.
To attach the E6L bezel:
1 Before installing the bezel, write down the RTX Activation number printed on the ACTIVATION CODE sticker adhered to the
lower right of the E6L front panel. Keep the RTX number in a safe place to refer to after future System Restore procedures.
2 Locate the E6L bezel in the E6L package.
3 Set the bezel face down in front of the engine so you can connect its LED cable:
• Connect the multi-pin end of the cable to its connector on the bezel, being sure to orient the multi-pin correctly.
• Connect the other end to the jack on the front panel of the E6L.
4 Press the bezel into place and tighten the four captive screws to secure it to the E6L chassis.
Connecting the 1/8-inch connector
To Next Page
Loading...
Need help?
General
