Azbil C35 Series - Page 198

6-22
Chapter 6. LIST OF DISPLAYS AND SETTING DATA

DI Assignment bank
Bank selection:
Display Item Contents
Initial
value
User
level
Notes
Internal Contact 1
Operation type
0: No function
1: LSP group selection (0/+1)
2: LSP group selection (0/+2)
3: LSP group selection (0/+4)
4: PID group selection (0/+1)
5: PID group selection (0/+2)
6: PID group selection (0/+4)
7: RUN/READY selection
8: AUTO/MANUAL selection
9: LSP/RSP selection
10: AT Stop/Start
11: Invalid
12: Control action direct/reverse
selection (As setting/opposite
operation of setting)
13: SP RAMP enabled/disabled
14: PV Hold (No-hold/Hold)
15: PV maximum value hold (No-
hold/Hold)
16: PV minimum value hold (No-
hold/Hold)
17: Timer Stop/Start
18: Release all DO latches (Continue/
Release)
19: Advance (No-advance/Advance)
20: Step hold (No-hold/Hold)
0 0
Internal Contact 1
Input bit function
0: Not used (Default input)
1: Function 1 ((A and B) or (C and D))
2: Function 2 ((A or B) and (C or D))
3: Function 3 (A or B or C or D)
4: Function 4 (A and B and C and D)
0 2 When using internal contact
1, the default input is digital
input (DI) 1.
(Continue on next page.)