Azbil C35 Series - Page 199

6-23
Chapter 6. LIST OF DISPLAYS AND SETTING DATA
Display Item Contents
Initial
value
User
level
Notes
Internal Contact 1
Input assignment A
0: Normally opened. (OFF, 0)
1: Normally closed. (ON, 1)
2: DI1
3: DI2
4: DI3
5: DI4
6 to 9: Undefined.
10: Internal Event 1
11: Internal Event 2
12: Internal Event 3
13: Internal Event 4
14: Internal Event 5
15: Internal Event 6
16: Internal Event 7
17: Internal Event 8
18: Communication DI1
19: Communication DI2
20: Communication DI3
21: Communication DI4
22: MANUAL mode
23: READY mode
24: RSP mode
25: AT running
26: During SP ramp
27: Undefined.
28: Alarm occurs.
29: PV alarm occurs.
30: Undefined.
31: mode key pressing status
32: Event output 1 status
33: Control output 1 status
2 2 Displayed when internal
contact 1 Input bit function is
set 1 to 4 (
DI 1.2
≠0).
Internal Contact 1
Input assignment B
0 2
Internal Contact 1
Input assignment C
0 2
Internal Contact 1
Input assignment D
0 2
Internal Contact 1
Polarity A to D
1st digit: Polarity A
(Polarity of Input
assignment A)
2nd digit: Polarity
B (Polarity of Input
assignment B)
3rd digit: Polarity
C (Polarity of Input
assignment C)
4th digit: Polarity
D (Polarity of Input
assignment D)
Digits are assigned from right to left
in the order 1, 2, 3, 4.
0: Direct
1: Reverse
0000 2 Displayed when internal
contact 1 Input bit function is
set 1 to 4 (
DI 1.2
≠0).
Internal Contact 1
Polarity
0: Direct
1: Reverse
0 2
Internal Contact 1
Event channel def.
0: Every Internal Event
1 to 8: Internal Event No.
0 2 Displayed when the
operation type of internal
contact 1 is timer stop/start
(
DI 1. 1
= 17).
Internal Contact 2
Operation type
Same as Internal Contact 1
Operation type.
0 0
Internal Contact 2
Input bit function
Same as Internal Contact 1 Input bit
function.
0: Not used. (Default input)
1 to 4: Function 1 to 4
0 2 When using internal contact
2, the default input is digital
input (DI) 2.
(Continue on next page.)