Azbil C35 Series

Index-2
C68 Data format (Parity) 7-1
C69 Data format (Stop bit) 7-1
C70 Response time-out 7-1
C71 Key operation mode/type 5-94
C72 [mode] key function 5-94
C73 MODE display setup 5-95
C74 PV/SP display setup 5-96
C75 MV display setup 5-97
C76 Event setting value display setup 5-98
C77 Event remaining time display setup 5-98
C78 CT input current value display setup 5-99
C79 User level 5-99
C80 LED monitor 5-99
C81 MS indicating lamp ON condition
(1st priority) 5-100
C82 MS indicating lamp ON status
(1st priority) 5-100
C83 MS indicating lamp ON condition
(2nd priority) 5-100
C84 MS indicating lamp ON status
(2nd priority) 5-100
C85 MS indicating lamp ON condition
(3rd priority) 5-100
C86 MS indicating lamp ON status
(3rd priority) 5-100
C87 MS indicating lamp deviation range 5-100
C88 Special function 5-8
C89 Zener barrier adjustment 5-8
C90 Number of CT1 turns 5-92
C91 Number of CT1 power wire loops 5-92
C92 Number of CT2 turns 5-92
C93 Number of CT2 power wire loops 5-92
C97 PV input failure (under range) type 5-6
Calibration of current output/continuous
voltage output 11-6
Calibration 11-1
Cap 1-4
CE marking 1-1
Checksum (LRC) 8-3
Checksum 7-4
Cold junction compensation (T/C) 5-1, 5-3
Command
RD command 7-9
RS command 7-7
RU command 7-11
WD command 7-10
WS command 7-8
WU command 7-12
Communication data 9-1
Communication DI 5-11
Communication lock 5-107
Communication mode 7-1
Communication monitor display 5-99
Communication function 7-1
Communication procedures 7-2, 8-2
Connection of communication cable 4-6
Console display 5-94
Console 1-4, 1-5, 2-2
Constant current type 4-8
Continuous data read 7-7
Continuous data write 7-8
Continuous output 5-87
Continuous voltage output 5-86
Control action (Direct/Reverse) 5-15
Control algorithm 5-28
Control method 5-14
Controller alarm OR 5-67
CPL communication 7-1
CR filter 4-12
Crimp type terminal 4-5
Current transformer (CT) input 2-1, 5-89
CT display setup 5-99
CT input calibration 11-5
CT measurement wait time 5-91
CT operation type 5-89, 5-91
CT output 5-91
Current output 5-87
Current transformer input 2-1
Current transformer 1-3
D
Data Address
7-13, 8-11
Data format 7-1
Data link layer 7-3
Data setting procedures 2-4
Decimal point position 5-1, 5-5
Delay unit 5-67
Derivative time 5-19
Device ID code 7-3, 7-4
DI Assignment, Internal contact 5-37, 5-42