Azbil C35 Series User Manual

Index-3
DI 2-1, 5-51
Digital input 2-1, 4-6
Display at power ON 2-3
DISPOSAL 12-1
DO 5-71
E
Energy saving
5-24
EV display setup 5-98
Event output 2-1
Event 5-58
Alarm 5-64
Control action (Direct) 5-64
Deviation high limit 5-59
Deviation high/low limit 5-60
Deviation low limit 5-59
During AT 5-64
During SP ramp 5-64
During estimated position control 5-64
Heater 1 burnout 5-60
Heater 1 short-circuit 5-60
Heater 2 burnout 5-60
Heater 2 short-circuit 5-60
Invalid 5-64
Loop diagnosis 5-61, 5-62, 5-63
MANUAL 5-64
MV high limit 5-60
MV high/low limit 5-60
MV low limit 5-60
PV high limit 5-59
PV high/low limit 5-59
PV low limit 5-59
READY 5-64
RSP 5-64
SP high limit 5-60
SP high/low limit 5-60
SP low limit 5-60
Timer 5-64
External dimensions 3-2
F
Fixed length continuous data read
7-9
Fixed length continuous data write 7-10
Fixed length random data read 7-11
Fixed length random data write 7-12
Fuse replacement 10-1
G
Gain adjustment
11-3
Gang-mounting 3-2
H
Hard cover
1-3, 3-4
Heat/Cool change point 5-24
Heat/Cool control calculation 5-24
Heat/Cool control deadband 5-24
Heat/Cool control 5-15
Heat/Cool 5-24
High function configuration 2-7
Host device 7-1
Hysteresis 5-68
I
I/O check
11-2
IEC directive 1-1
Initial output of PID control 5-17
Initial output 5-19
Initialization 5-16
Input assign polarity 5-56
Input assign 5-55
Input bit function 5-51, 5-54
input types 1-1
Input with motor fully closed 5-115
Input with motor fully open 5-115
Installation place 3-1
Integration time 5-19
Internal contact operation type 5-52
Internal contact 5-51
Internal event No. definition 5-53
Internal Event Operation type 5-65
Internal Event 5-51
Isolation 13-4
J
Jack cover
1-4, 1-6
Just-FiTTER assistance coefficient 5-28
Just-FiTTER settling band 5-28
Just-FiTTER 1-1, 5-28

Azbil C35 Series Specifications

General

Brand	Azbil
Model	C35 Series
Category	Controller
Language	English