2-23
Chapter 2 Installation of this Device
(2) Installing Instructions
This section explains the installation of the flushing ring, piping method and other important
matters. In order to properly use the flushing ring, install it according to the conditions described
below.
(i) Installation site selection
Choose the location of the flushing ring according to the following conditions.
• If there is a possibility of the process fluid to freeze, take heat insulation measures.
• Select a location with the least impact and vibration.
• Avoid installing in a corrosive atmosphere.
(ii) Installation dimensions
Refer to the dimensional drawing in the specification sheet or approval drawing for the dimensions
of the flushing ring.
(iii) Installation procedure
Warning
Do not use this device for fluids such as toxic gas that may result in harmful physical
risks due to minute leaks.
During installation, make sure that the gasket does not stick out at the connection with
the process. There is a risk that the process fluid will leak out and may result in burns or
other injuries.
Close the vent/drain plug during operation. There is a risk that the process fluid will leak
out and may result in burns or other injuries.
If the process fluid contains toxic substances, take safety measures such as wearing
goggles and masks to prevent contact with the skin and eyes and to prevent inhalation.
Caution
Use both hands to when carrying this instrument. If dropped, it may cause injuries or
may damage the instrument.
The protection cover for the sealing surface is not a gasket. Failing to remove it before
installing may result in leakage of the process fluid.
To Next Page
Loading...
Need help?
General
