Azbil Corporation Operation using the data setting device
Model MTG11A/18A, MTG11B/18B, MTG14C 6-7
Key names and functions
This section describes the functions assigned to the orange keys, which are mainly
used to communicate with the converter or to select a screen or to select from the
menu.
Key
Description
Press key Press SHIFT + key
SET: Used for setting correction
coefficient in LRV setting.
No effect
NEXT: Scrolls up the screen in the
CONFIG function.
No effect
PREV: Scrolls down the screen in
the CONFIG function.
No effect
OUTPUT: Displays a value in
percentage, which is transmitted by
the converter to the control loop.
INPUT: Displays an
instantaneous flow rate value
detected by the converter in a
real flow rate.
CORRECT: Press this key to adjust
the zero point of the converter. This
operation is available while INPUT
(input) is being read.
RESET: Resets the internal
data of the converter to the
factory setting.
ENTER: Press this key to answer
“Yes” to a question on the screen.
The screen will move one step up or
down or data set by the SFC is
written into the database of the
converter.
NON-VOL: The data set by
the SFC is forcibly written into
non-volatile memory of the
converter.
CM2-MTG300-2001.book 7 ページ ２０１５年９月２９日 火曜日 午前１０時１４分
To Next Page
Loading...
