Operation using the data setting device Azbil Corporation
6-8 Model MTG11A/18A, MTG11B/18B, MTG14C
Key names and functions
This section describes the functions assigned to the yellow keys which are used to
enter numerals.
Key
Description
Press key Press SHIFT + key
9: Enters numeral 9. PRINT: Prints out internal data of the
converter. This printing operation is called
“configuration printout”.
8: Enters numeral 8.
FEED: Advances printing paper by 1 line. The
display window shows “PRINTER FEED”. As
long as this prompt is displayed, each pressing
of this key advances paper by 1 line. To cancel
this operation, press the CLR key.
to
7 to 4: Enters numeral 7
to 4.
No effect
3: Enters numeral 3. Displays the software versions of the
converter and SFC. If the SFC is not
communicating with the converter, only the
version of the SFC is shown.
2: Enters numeral 2. Displays “KEYBAORD TEST row*
column*” and then displays the row and
column of the key pressed immediately
after. Used to check the keyboard for any
problems.
1: Enters numeral 1. No effect
0: Enters numeral 0. ACT PR: Prints out a response from the
converter every time the key is operated.
This operation is called “action printout”.
: Enters a decimal
point.
SCR PAD: Writes a memo into the database
of the converter.
Inverts the sign in the
case of numerical input.
TIME: Displays the current year, month,
day and time.
CM2-MTG300-2001.book 8 ページ ２０１５年９月２９日 火曜日 午前１０時１４分
To Next Page
Loading...
