Baby Lock Pro-Stitcher BLPS3 - Required Tools and Rack Installation

Pro-Stcher User Manual Installaon | 3.5
Installaon
Tools required
• Power drill
• 4mm Allen wrench
• 5mm Allen wrench
• Sloed screwdriver (one large and one small)
• Phillips screwdriver (one large and one small)
• Manual engagement/disengagement tool (see Parts List, item O)
Installaon of the X-Rack and Y-Rack
To install the X-Rack
1. Remove the blue 12-foot Flexirack (see Parts List, item
A) and the Pro-Stcher carriage (see Parts List, item E)
from the box.
2. Place the Pro-Stcher carriage on the frame. Starng
at one end of the table, begin mounng the blue
Flexirack to the front of the table while aligning it to
the front white gear on the carriage.
Peel back a few inches of the pink protecve layer
of the tape. Posion the blue Flexirack by aligning it
to the white gear as you move down the table. Press
down on the blue Flexirack to sck it rmly to the
table.