Balluff BVS HS-P Series - Docking Beep; Leash Alarm

212
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
Docking Beep Enables/disables a beep indication when the handheld is placed in the Base Station.
Leash Alarm This setting specifies the number of seconds to sound the Leash Mode beeps (three per second)
when the handheld goes out of range. This is especially useful in instances where the reader
might inadvertently have been placed in a bag or cart.
For this mode to be effective, the reader must be linked to the Base Station. If the reader is asleep
or disconnected from the Base Station, there is no way for it to know where it is relative to the
Base Station because communication is not active between the devices.
Docking Beep = Disable
Docking Beep = Enable
$CBTCB00(CR
$CBTCB01(C
DEFAULT
Leash Alarm = Disabled
Leash Alarm = 1 Second
Leash Alarm = 2 Seconds
Leash Alarm = 3 Seconds
DEFAULT
$CBTLB00(CR
$CBTLB01(CR
$CBTLB02(CR
$CBTLB03(CR