40
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Bar Code Readers
ACK Character This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
page 240 for more information.
NAK Character This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
See page 241 for more information.
NOTE
Setting to previously defined characters such as XON, XOFF, or host commands
conflicts with normal operation of these characters. 8-bit data is not recognized
when the option Data Bits has been set as 7 Data Bits.
Select ACK Character Setting
NOTE
Setting to previously defined characters such as XON, XOFF, or host commands
conflicts with normal operation of these characters. 8-bit data is not recognized
when the option
Data Bits has been set as 7 Data Bits.
Select NAK Character Setting