Balluff BVS HS-P Series - Set PIN Code

227
www.balluff.com
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
Set PIN Code Determine the desired characters for the PIN code, then convert to hexadecimal using the ASCII
Chart on page 313 on the inside back cover of this manual. See page 271 for detailed information
and examples for setting this feature.
Set 4-character Bluetooth PIN Code
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the hexadecimal digits from the Alphanumeric
characters in
Appendix D: Keypad represent-
ing your desired character(s). End by reading
the ENTER/EXIT barcode again.
Set 16-character Bluetooth PIN Code
CANCEL
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
$CBTPC
$CBTP6
~
DEFAULT
31323334 = Default PIN Code is 1234