Balluff BVS HS-P Series - Batch Features; Batch Mode; Send Batch

215
www.balluff.com
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3.11.3 Batch Features
Batch Mode This option specifies whether to store labels in the handheld while disconnected from the base.
Options are as follows:
- Disabled — The handheld will not store/batch labels.
- Automatic — The handheld will store labels to RAM when the handheld goes out of range and
is disconnected from the remote device.
- Manual — The handheld will always store labels to Flash memory. The user must manually
send the stored labels to the remote device using a special "batch send" label.
Send Batch When the reader is configured in Manual Batch Mode, use the following barcode to initiate send-
ing of labels stored in batch memory.
Batch Mode = Disabled
Batch Mode = Automatic
Batch Mode = Manual
DEFAULT
$CBTBM00(C
$CBTBM01(C
$CBTBM02(C
NOTE
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunction
with this barcode.
BatchSend
Send Batch