Balluff BVS HS-P Series

To Next Page

To Previous Page

250

References

Balluff BVS HS-P Family

Industrial Handheld Barcode Readers

Set Length 2 This feature allows you to set one of the barcode lengths for the specified symbology. Length 2 is

the maximum label length if in

Variable Length Mode, or the second fixed length if in Fixed Length

Mode. See the page for the specific symbology for parameters.

The length that can be set varies depending on the symbology. A setting of 0 specifies to ignore

this length (only one fixed length).

Follow these instructions to set this feature:

1 Determine the desired character length (from 1 to 50 — or 0 to ignore this length). Pad the

number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

2 Go to the Set Length page for your selected symbology and scan the ENTER/EXIT PRO-

GRAMMING MODE barcode to enter Programming Mode.

3 Scan the barcode to SELECT LENGTH 2 SETTING for your selected symbology.

4 Scan the appropriate two digits from the keypad in Appendix D: Keypad that represent the

length setting which was determined in the steps above. You will hear a two-beep indication

after the last character.

5 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure.

NOTE

If you make a mistake, before the last character scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

Balluff BVS HS-P Series - Page 250