Balluff BVS HS-P Series User Manual

50
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
Wedge Quiet
Interval
Specifies amount of time to look for keyboard activity before reader breaks keyboard connection
in order to transmit data to host. The selectable range for this setting is 00 to 990 milliseconds
(00-0x63 by 01) in increments of ten milliseconds.
See page 246 in “References” for detailed
information and examples for setting this feature.
Intercode Delay Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
See page 248 in “References” for detailed information and examples for setting this feature.
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CKBQI
~
DEFAULT
0A = Quiet Interval is
100 milliseconds
Set Intercode Delay
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CKBID
~
DEFAULT
00 = No Wedge Intercode Delay

Balluff BVS HS-P Series Specifications

General

Brand	Balluff
Model	BVS HS-P Series
Category	Barcode Reader
Language	English