Balluff BVS HS-P Series - Page 72

72
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3.7.2 LED and Beeper
Indicators
Power On Alert Disables or enables the indication (from the Beeper) that the reader is receiving power.
Good Read:
When to
Indicate
This feature specifies when the reader will provide indication (beep and/or flash its green LED)
upon successfully reading a barcode.
Power On Alert =
Disable (No Audible Indication)
Power On Alert = Power-up Beep
$CBP-
$CBP-
DEFAULT
Indicate Good Read = After Decode
Indicate Good Read = After Transmit
Indicate Good Read =
After CTS goes inactive then active
DEFAULT
$CBPIN00(CR)
$CBPIN01(CR)
$CBPIN02(CR)