Barco PDS - PDS Command List

PDS • User’s Guide 119
_K==oÉãçíÉ=`çåíêçä
PDS Command List
map=`çãã~åÇ=iáëí
The table below lists PDS remote commands.
Note
The following commands are for the PDS-902 and PDS-901
units. For a PDS-701 unit, the input parameter range cannot
include inputs 7 or 8.
Table B-3. PDS Remote Commands
Command Description Page
Ethernet Commands
DHCP
Enable/Disable DHCP mode 123
EMAC Get MAC Address 123
GATEWAY Set gateway to be used when DHCP is OFF 124
IP Set Static IP Address to be used when DHCP is OFF 124
SUBNET Set subnet mask to be used when DHCP is OFF 124
Input Commands
BLKVID
Puts black into the program input 125
CBLEQ Set cable equalization 125
EDID Set Input EDID Resolution 125
EDIDTYPE Set EDID type 125
FREEZE Freeze the input on program 126
IADJ Selects the input path to adjust (preview or program) 126
IADJRST Reset the input timing parameters to default values for analog. 126
IAR Adjust Input Aspect Ratio 126
IAUTOACK Input Source Acquire Mode 127
IAUTOC Attempts to detect and adjust input video to the active video area 127
IAVAIL Query only command for input availability 127
IBRT Input brightness adjust 128
ICDEL Delete Input Configuration 128
ICNT Input contrast adjust 128
ICPHO Input Phase Adjust 128
ICREC Recalls saved input configuration for selected input 129
ICRST Reset Input Configuration to default values 129
ICSAV Saves Input Configuration 129