PDS • User’s Guide 121
_K==oÉãçíÉ=`çåíêçä
PDS Command List
OSYNC Output Sync Type Adjust 140
OTPM Output Test Pattern Mode 140
OTPT Output Test Pattern Type 140
System Commands
AUTOACQ
Auto Input Acquisition Mode 142
AUTOCFG Auto Input Configuration Mode 142
AUTOSAVE Auto Input Settings Save 142
AUTOTAKE Auto Take Mode 142
BACKGND Set background color 142
BLKTRAN Set whether going to black is a direct cut or setup for a take 143
CONMODE Encore Connect Mode 143
CONTEXT Set menu context 143
DIAG Perform a system diagnostic test 143
DIAGD Display the results of the last performed system diagnostic test 143
ENCOREIP Encore IP address 144
FPUPDATE Request a front panel update 144
ISTAT Query only command for the input status type and format 144
LCLR Clear the selected log (ram copy, not flash) 144
LDMP Display the current log messages 144
LFEN Set the mode for the selected log 145
LINT Set the time interval for writing the enabled logs to flash 145
LOCKOUT Control the lockout mode of the front panel 145
OSTAT Query only command for the output status type and format 145
PREVIEW Query only command for the input and black button status on preview 145
PROGRAM Query only command for the input and black button status on program 146
RESET Reset unit 146
SAVE System Save 146
SERIAL Sets the serial port 146
TEMP Query only command for the temperature of the unit 147
TRNTIME Set transition time 147
UNITID Encore Unit ID 147
VER Display Version info 147
VFDBRT Set VFD brightness 147
Table B-3. PDS Remote Commands (Continued)
Command Description Page
To Next Page
Loading...
