8 Safety
CFPP Process Analyzer CFPP-4.2 03/2016
This chapter gives you an overview of the most important safety issues.
2.1 General
The analyzer may be dangerous if the safety instructions are not observed, or if the
analyzer is used for purposes for which it is not intended, or if it is operated by unqualified
personnel.
Make sure that any person working with the analyzer has first read and understood the
operating instructions. This is also necessary if the person has worked with a similar
analyzer before or has been trained for this purpose.
Also observe the detailed safety instructions in the individual chapters. They are
highlighted with signal words and symbols. In addition, observe the notes and instructions
on the instrument and keep them readable. Also observe the safety instructions in the
supplied operation manuals of all built-in equipment and components. Observe the
information on operation, maintenance and servicing.
2.2 Intended Use
The CFPP Process Analyzer CFPP-4.2 is designed for determining in a fully automated
process the temperature limit value for the filterability of liquid petrochemical products. A
sample stream and a calibration stream (optional) can be connected to the analyzer, which
operates online. It is intended to monitor the quality of production in the process and also
the compliance with mandatory specifications for petrochemical products.
The analyzer is intended exclusively for stationary operation in an analysis building.
The analyzer may only be used for products which correspond to the specification defined
at the time of ordering.
The analyzer is designed for operating in zones 1 and 2 of potentially explosive areas
caused by gases. Make sure that no other gases (e.g. hydrogen or oxygen used by other
analyzers) and no other vapors or liquids can reach the analyzer through the vent- drain-
system (vent = waste gas outlet; drain = waste liquid outlet).
It is not permissible to make any technical modifications to the analyzer without written
authorization from BARTEC BENKE.
Use only spare parts supplied by BARTEC BENKE.
To Next Page
Loading...
General
