BARTEC BENKE CFPP-4.2 - 5.5 Sample conditioning system (optional)

Analyzer Description 39
03/2016 CFPP Process Analyzer CFPP-4.2
5.5 Sample conditioning system (optional)
The following illustration shows a standard sample conditioning system.
Fig. 5.6: Sample conditioning system (example)
The standard sample conditioning system consists of the following main components listed
here in the sample flow direction:
• Inlet valve, connection for product inlet (4)
• Pressure regulator (3)
• Laboratory sampling point (5)
• Pressure gauge (2)
• Fine filter with bypass valves (1)
• Heat exchanger (8)
• Thermometer (13)
• Water separator (coalescer) (12)
• Flow meter for the water separator outlet (9) with connector for outlet
• Switching valve for validation product (11) with connector for validation
product
• Flow meter for product (10) with connector for product outlet
• Control valve for cooling water (6)
• Shut-off valves for cooling water (7)
Note: The description given here refers to the standard system. For a detailed
description of your sample conditioning system, please refer to the technical
documents supplied.
1
2
3
4
5
6
7
8
9
10
11
12
13