Safety 17
03/2016 CFPP Process Analyzer CFPP-4.2
Chiller for Liquids
The housing of the chiller for Liquids (9) with its removable covers (8, 9, 13) ensures
protection against contact and foreign matter as well as protection against moisture, and
thus prevents damage to the electrical equipment. The upper cover (8) is fastened with
screws. You can remove the front cover (9) easily with a key. The covers must be closed
during normal analyzer operation.
Note: Further information to the Chiller for Liquids you find in the provided manual
for the Chiller for Liquids.
Labeling
The mandatory-signs (22, 23) in the measuring unit enclosure indicate that you must wear
protective goggles and protective gloves while you work in the measuring unit enclosure.
The warning labels (14 respectively 20) indicate that the measuring unit enclosure
contains electrical equipment respectively units with hot surfaces. The warning label (15)
indicates that the measuring cell housing contains actuated units with very cold surfaces.
Before opening the measuring cell housing wait always for warming up of the units in the
measuring cell housing.
You must check the protective devices at regular intervals. For further
information, please refer to chapter 10.4. The protective devices must never be
removed, bypassed or made unusable in any way. The warning labels must be
kept easily readable. Spare warning labels are available from BARTEC BENKE.
2.6 Personnel
Personnel working with the analyzer must be trained, authorized and instructed,
particularly with respect to possible hazards. Personnel must be qualified for the task. Due
to their training, experience and knowledge, particularly of applicable regulations, qualified
persons can assess and thus avoid the potential risks of a task.
Persons who carry out checks and maintenance work on the analyzer must be qualified
according to EN 60079-17 / IEC 60079-17.
To Next Page
Loading...
General
